Spypoint FORCE-10 - Page 5

5
FORCE
1 LEDs Night lighting to obtain black and white photos
and videos.
2 Photo lens Image sensor and infrared lter.
3 Test light Flashes in TEST mode when there is detec-
tion and ashes 60 seconds in PHOTO/VIDEO
mode to allow the user to leave without being
photographed or recorded.
4 Cable lock hole Allows the user to install a CL-6FT cable lock,
sold separately.
5 Light sensor Allows the lighting of the LEDs panel at night.
6 Motion sensor Expands the detection area and increases the
sensitivity of the camera’s motion sensor.
7 1) 12V power jack 1) This camera can be powered from an
external 12-volt DC input such as a 12V
battery or a 12V adapter, each sold
separately.
8 Microphone Records sound in video mode.
9 BUSY LED Lights up when TEST mode is activated.
10 Slot for installation
strap
Allows the user to install the camera using
the installation strap included.
11 Tripod mount Standard ¼-20" tripod mount.
12 Battery case Case for AA batteries or a rechargeable
lithium battery pack.
13 OK button Allows the user to make a selection.
14 Navigation buttons Buttons to set the camera.
15 ON/OFF button Allows the user to turn on/o the camera.
16 Conguration screen
(FORCE-10 & comparable )
Allows the user to congure the settings of the
camera through the main menu.
Viewign screen
(FORCE-11D & comparable)
Allows the user to access the main menu and
view photos/videos.
17 SD card slot An SD card is required to record photos/
videos.
Components