Spypoint LINK-MICRO-S-LTE - Power Supply; Before First Use, Charge the Lithium Battery Pack; Operation; Lithium Battery Pack Specifications

LINK-MICRO-S-LTE
7
SPYPOINT
The main power source of your camera is the lithium battery pack
(#LIT-10 included), which provides a long charge time, more than double
that of AA batteries.
BEFORE YOUR FIRST USE, CHARGE
THE LITHIUM BATTERY PACK
• Remove the lithium battery pack from the
packaging. It is shipped with the camera.
• Using ONLY the supplied micro-USB cable and a
5 V wall outlet charger (not included), recharge
the battery pack for about 12 hours. Plug the
end of the cable (micro-USB part) in the battery
pack provided for this purpose. Then plug the
other end (USB part) into a wall outlet adapter.
• Once the lithium pack is fully charged,
the red light will turn green.
• After unlocking the latch and opening the
camera door, insert the battery pack in the
compartment (see photo).
Do not insert AA batteries into the lithium
battery compartment, as this could damage the camera.
OPERATION
• The solar panel is not an autonomous power source for your camera. Its only
function is to maintain the charge of the lithium battery or to slowly charge
it. The solar panel will be eective as soon as ambient solar energyis detected.
• Make sure there are no objects or elements obstructing the solar panel
(e.g.: snow). If it is partially covered, the solar panel will still work, but to a
limited extent. For optimal performance, it must be completely clear.

• Under optimal conditions (a conguration that consumes little energy), the
energy and a sunny environment), the power supply of the camera will be
autonomous.
• When the battery pack's charge level is low, you will receive a notication
in your app.
• If your battery pack runs out, the camera will shut down.
• If the camera turns o, the solar panel will continue to power the battery
pack. However, for a quick and complete recharge, connect the battery pack
to a wall outlet using the supplied USB cable and a USB power adapter.
• When you restart your camera, after recharging the battery pack, it will
return to the settings you previously selected.
LITHIUM BATTERY PACK SPECIFICATIONS
This lithium battery is compatible with all SPYPOINT LINK-MICRO
cameras and the CELL-LINK.
Charging time ≈ 12 hours (with micro-USB cable)
Operating
temperature -30 °C to 50 °C (-22 °F to 122 °F)
Storage
temperature -40 °C to 60 °C (-40 °F to 140 °F)
Voltage 3.7 V
Capacity 10,200 mAh
Power Supply