In the box
Recommendations
Components
Note: Memory card and batteries are sold separately.
To ensure maximum performance of the camera and prevent
battery leak, we recommend the use of new batteries. Make sure
to insert each battery with the correct polarity. (Negative or at
end agaist the metal spring plate) Do not mix battery type - use
ALL alkaline or ALL lithium. Do not mix old and new batteries.
Rechargeable AA batteries are not recommended as the lower
voltage they produce can cause operational issues.
4. INSERT THE MEMORY CARD
Before inserting or removing a memory card, always turn o the camera
to prevent loss or damage of the photos already recorded. Also make
sure that the switch on the side of the card is not in the LOCK position.
Insert an SD/SDHC memory card (up to 32 GB capacity) in the card
slot with the label side facing upward. The card is inserted correctly
when a click is heard.
We suggest to format your SD card if it's been in another electronic
device to make sure you will have the maximum capacity of your
memory card.
1. CHARGING THE INTERNAL BATTERY
First, look at the internal battery percentage in the DETECTION TEST
menu. If the percentage is low and the battery logo is not green, you
will need to charge the camera for 24-48 hours before use. While
charging, make sure the camera is turned o and the solar panel is
facing down so it does not interfere with the USB charging process.
Plug the cable from the 12V port at the bottom of the camera and
connect it to a USB port. (ex. USB power adaptor or a computer that
will stay awake while charging) Once plugged, the screen will turn on
and it will show the charging battery level for 10 seconds. Press the OK
button once more to see the battery level reappear.*
2. REMOVE THE CAMERA FROM THE MOUNTING BRACKET
• Push the tab to release the camera from the mounting bracket.
• Remove the camera.
3. OPTIONAL: ADD A SECONDARY POWER SOURCE
An optional power source can be added as a backup to the internal
battery for maximum protection.
Getting started
1 X Installation
strap
1X Quick
start guide
1 X Camera
1 X Mounting
bracket
RECHARGEABLE 7.4 VOLT LI-ION POLYMER BATTERY 2.0 Ah
RECYCLE OR DISPOSE OF PROPERLY
www.spypoint.com
P INTSPY INTPSPY
Models: LIT-09: Battery only
LIT-C-8: LIT-09 Battery & charger
WARNING: To reduce risk of fire or burns,
- Do not attempt to open, disassemble, or service the battery pack.
- Do not crush, puncture, short external contacts, or dispose
of in fire or water.
ATTENTION: Pour réduire les risques de feu ou de brûlures,
- Ne pas essayer d’ouvrir, désassembler, ou de réparer la pile.
- Ne pas frapper, percer, court-circuiter les contacts externes
de la pile ou mettre dans le feu ni l’eau.
6 alkaline or lithium
AA batteries
Lithium battery pack
LIT-09/LIT-C-8
DC 12V
12V power source
We recommend formatting Class 10 SD cards before using it in this unit.
A complete format of the card should be done.
PC: Make sure the «quick format» box is unchecked before proceeding.
MAC: Make sure to select MS-DOS (FAT) format.
Battery case
Slot for installation strap
Tripod mount
OK button
Navigation buttons
ON / OFF Switch
Viewing screen
SD card slot
Solar pannel
LEDs
Photo lens
Test light
Cable lock hole
Detection lens
12V Jack
BUSY LED
1
2
3
4
5
6
7
8
9
10
11
12
13
15
14
16
2
3
6
4
5
1
1 X USB-A
to barrel
connector
(44’’)
7
8
9
10
11
9
12
15
16
13
14
Join the community
Our goal is to design & manufacture
innovative, premium products for the
hunting industry and to cater to all hunters
passionate about the lifestyle that is
hunting. We strive on oering all customers
a positive, user friendly experience that will
have a lasting impression.
THANK YOU
for choosing
QUICK START GUIDE
SOLAR-W
• TRAIL CAMERAS
• HUNTING TABLET
• ACTION CAMERAS
& ACCESSORIES
v1.4
User manual, latest rmware
& FAQ available at:
www.support.spypoint.com
support@spypoint.com
1-888-779-7646
* 2017 cameras
To Next Page
Need help?
General
