65
SRAM VT 5000 / VT 3000
MAINTENANCE
Technical Manual 2006
Advice:
• Do not use high-pressure water when
cleaning the hub (e.g. strong water jets,
high-pressure cleaners etc.) – if water
penetrates the unit it could lead to
functional problems.
• Do not rinse hub with benzine, petroleum
etc. as this could produce impurities in
the brake pads.
MAINTENANCE
• Bearings is sufficiently lubricated and
essentially maintenance-free.
• Cable housing without inner tube:
lubricate regularly.
Caution:
The brake anchor plate must be replaced
if oil or other substances containing
grease get into the brake pads. Oily brake
pads reduce braking effect and cause the
brake to fail completely. This may result
in accidents with extremely serious
injuries.
To Next Page
Loading...
