SRAM G2 R User Manual

34
Lever Brake Hose Installation
Use a flare nut crowfoot with a torque wrench to tighten the Use a flare nut crowfoot with a torque wrench to tighten the
compression nut to 8 N·m (71 in-lb). compression nut to 8 N·m (71 in-lb).
Spray isopropyl alcohol on the lever body and clean it with a shop Spray isopropyl alcohol on the lever body and clean it with a shop
towel.towel.
Slide the hose boot onto the lever.Slide the hose boot onto the lever.
⚠ CAUTION
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
7
8 mm flare nut wrench 8 N·m (71 in-lb)

SRAM G2 R Specifications

General

Brand	SRAM
Model	G2 R
Category	Bicycle Accessories
Language	English