SRAM Guide T Caliper User Manual

16Disc Brake Pad and Rotor Bed-in Procedure
Disc Brake Pad and Rotor Bed-in Procedure
All new brake pads and rotors should be put through a wear-in process called 'bed-in'. The bed-in procedure, which should be performed prior to your
first ride, ensures the most consistent and powerful braking feel along with the quietest braking in most riding conditions. The bed-in process heats
up the brake pads and rotors, which deposits an even layer of brake pad material (transfer layer) to the braking surface of the rotor. This transfer layer
optimizes braking performance. To watch a video of the bed-in procedure, visit www.sram.com/service.
⚠ WARNING CRASH HAZARD
The bed-in process requires you to perform heavy braking. You must be familiar with the power and operation of disc brakes. Braking heavily when
not familiar with the power and operation of disc brakes could cause you to crash, which could lead to serious injury and/or death. If you are unfamiliar
with the power and operation of disc brakes, you should have the bed-in process performed by a qualified bicycle mechanic.
To safely achieve optimal results, remain seated on the bike during the entire bed-in procedure. Do not lock up the wheels at any point during the
bed-in procedure.
• Accelerate the bike to a moderate speed, then firmly apply the brakes until you are at walking speed. Repeat approximately twenty times.
• Accelerate the bike to a faster speed, then very firmly apply the brakes until you are at walking speed. Repeat approximately ten times.
• Allow the brakes to cool prior to any additional riding.
• After the bed-in procedure has been performed, the caliper may need to be re-centered.

SRAM Guide T Caliper Specifications

General

Brand	SRAM
Model	Guide T Caliper
Category	Bicycle Accessories
Language	English