25
Bleed Procedure
200 Hour Service Bleed Procedure
Insert the rebound adjuster knob or a 2.5 mm hex into the rebound Insert the rebound adjuster knob or a 2.5 mm hex into the rebound
shaft until it contacts the rebound adjuster screw. Rotate the knob shaft until it contacts the rebound adjuster screw. Rotate the knob
counter-clockwise until it stops to open the rebound. counter-clockwise until it stops to open the rebound.
Remove the rebound adjuster knob or hex from the shaft.Remove the rebound adjuster knob or hex from the shaft.
Fully extend the damper shaft, then remove the bleed screw from the Fully extend the damper shaft, then remove the bleed screw from the
top cap. top cap.
⚠ CAUTION EYE HAZARD
Oil will eject from the damper assembly if the shaft is compressed.
Wear safety glasses.
Hold the damper over an oil pan. Hold the damper over an oil pan. SlowlySlowly compress the rebound shaft compress the rebound shaft
to purge the oil from the port in the damper top cap. Cycle the rebound to purge the oil from the port in the damper top cap. Cycle the rebound
shaft to empty the oil from the damper top cap. shaft to empty the oil from the damper top cap.
⚠ CAUTION EYE HAZARD
Oil will eject from the damper assembly. Hold the damper top cap
downward to avoid oil spray in the eyes.
Fill a bleed syringe full with suspension oil. Slowly depress the plunger Fill a bleed syringe full with suspension oil. Slowly depress the plunger
to remove any air bubbles from the syringe. to remove any air bubbles from the syringe.
NOTICE
Only use the syringe included with the RockShox Standard Bleed kit.
Do not use syringes that have been in contact with DOT brake fluid.
DOT brake fluid will permanently damage the damper.
1
2.5 mm or Rebound Adjuster
2
T10
3
4
PLUSH 3wt RockShox Bleed Syringe
To Next Page
Loading...
Need help?
General
