SRAM RSC - Page 24

24Piston Assembly Installation
Place the SwingLink™ onto the SRAM Guide™ Lever Internals Assembly
Tool to adjust the length of the push rod on the SwingLink.
Use a 2 mm hex wrench to tighten the push rod into the SwingLink.
Use a 2 mm hex wrench to remove the SwingLink from the SRAM
Guide Lever Internals Assembly Tool and place the pushrod into the
coupler sleeve.
7
SRAM Guide Lever Internals Assembly Tool 15 N•m (133 in-lb) 22 mm
8
SRAM Guide Lever Internals Assembly Tool 2 mm hex wrench 22 mm
9
SRAM Guide Lever Internals Assembly Tool 2 mm hex wrench 22 mm
SRAM Guide Lever Internals Assembly Tool 2 mm hex wrench 22 mm