SRAM SPARC 16V User Manual

Sparc · July 2004
11
E
MAINTENANCE AND CARE
CLEANING / REPAIR WORK
CLEANING
» Your Sparc components are well
protected against adverse envi-
ronmental influences. In order to
avoid malfunction due to water
penetration pressurized jets (high
pressure cleaners etc.) should
not be used when cleaning the
bicycle.
» When using the bike during the
winter more frequent cleaning is
necessary to prevent damage
caused by de-icing salt.
REPAIR WORK
Arrange for any work, which
may become necessary on
the electrical drive system, the
cable harness, the battery or the
charging unit, to be carried out by
your qualified specialist dealer.
» Non-authorized work on your
Sparc system could put you in
danger and also lead to the loss of
your guaranteed rights.
» If you have questions or problems
please contact your qualified
specialist dealer.
Problem
Difficulties when shifting
(5-gear hub)
Pedals move forward
when freewheeling
Electric drive does not
work
Electric drive makes an
unusual noise
Cause
Damaged cable
Wrong setting
Chain is too tight
Remote control switch in
position OFF
Remote control switch
defective
Plug connections
Cable defective
Battery empty
Battery defective
Fuse blown
Electric drive defective
Electric drive contaminated
Electric drive defective
Remedy
Replace cable
Adjust gearshift
Slacken chain tension
Shift to ECON or SPEED
Have remote control switch
replaced
Slide all plugs completely
in slots
Have cable replaced
Charge battery
Have battery replaced
Have fuse replaced
Have electric drive replaced
Have contamination removed
Have electric drive replaced
TROUBLESHOOTING

SRAM SPARC 16V Specifications

General

Brand	SRAM
Model	SPARC 16V
Category	Bicycle Accessories
Language	English