SRM X-Power - Step 5: Set Crank Length; Step 6: Zero Load Calibration; Step 7: Angle Calibration; Step 8: Ride Ready

11
Step 5:
Choose the correct crank
length of your crankset.
Step 6: Zero Load Calibration
I NOTE
Ensure there is no load on the pedal
while performing the o󰀨set calibration!
Continue with next step when
successful.
Repeat this step if calibration fails!
Step 7: Angle Calibration
NOTE
Make sure the right crank
is facing directly down (at
90 degrees to the ground as
in the graphic on screen).
and the bike is on a level
(horizontal) and at surface
when performing this
calibration step.
Step 8:
If the angle calibration is successful
you are all set and ready to go for a
ride!
If angle calibration fails repeat this
step until completion! Make sure the
crank doesn’t move while performing
the angle calibration.