IN CASE OF EMERGENCY
12-17
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
If one of these symptoms happens, reset the automatic trans-
mission safe mode.
Shift Lever Lock Release
How to Reset the Safety Mode
1. Park the vehicle and place the selector lever to the “P” position.
2. Stop the engine and wait for over 10 seconds.
3. Start the engine.
Symptoms after Resetting of the Safety Mode
SHIFT LEVER LOCK RELEASE AND SAFETY MODE RESET
1. Apply the parking brake firmly and turn the ignition off.
2. Push the shift lock release lever by inserting a proper stick.
Then, with the brake pedal depressed, move the selector
lever to
“N”.
3. Start the engine, release the parking brake, and place the
selector lever to the
“-D+” position.
• Heavy shock when moving the selector lever
• Decreased driving force while driving at a high speed
• Fixed gear position during driving
• If the automatic gear selector does not move out of “P”, take the
steps mentioned above and take the vehicle to a Ssangyong dealer
or authorized service center. Have the vehicle checked and repaired.
• The brake pedal must be depressed when you try to move the
selector.
WARNING
If abnormal operation of the transmission (fixed at the 2nd forward
gear in the “-D+” position or the 2nd reverse gear in the “R” position)
still exists, have the system check by a Ssangyong Dealer or
Ssangyong Authorized Service Center.
WARNING
12-In Case of Emergency.p65 2006-10-03, ¿ÀÈÄ 2:36Page 17 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
