SEAT AND RESTRAINT 4–19
WARNING
Loosely secured child restraint sys-
tem can cause serious injury.
•
Tighten anchor bolt firmly.
•
Anchor bolt must be engaged at
least 5 full threads in the anchor-
age.
•
Adjust restraint system as firmly
as possible.
•
Never use infant carrier or child
safety seat that hooks over a seat
back.
CAUTION
Unused child restraint system could
move forward.
Remove child restraint system if not
in use, or secure it with safety belt.
CAUTION
Exhaust gases could enter the vehicle
interior.
Cover the unused anchor holes with
the supplied plug or suitable bolts.
CAUTION
Exhaust gases could enter the vehicle
interior.
Cover the unused anchor holes with
the supplied plug or suitable bolts.
NOTE
Since a safety belt or child restraint
system can become very hot if it is
left in a closed vehicle, be sure and
check the seat cover and buckles
before placing a child there.
Installation of the attaching clip
Positive engagement of the child restraint
attaching clip is achieved by depressing
retainer spring and then opening of the an-
chor fitting as shown in the illustration.
Method of installation of anchor engagement
1. Child restraint anchor fitting
2. Attachment bolt
3. Lock washer
A 5/16"-UNC-2B-bolt with a thread length of
30 mm is used to attach the anchor fittings
to the vehicle anchorage.
For fitting advice, please contact your au-
thorized Ssangyong Dealer.
Child restraint attaching clip
New Rexton04_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:32Page 19 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
