3–10 INSTRUMENTS AND CONTROLS
POWER MODE INDICATOR
(FOR AUTOMATIC TRANSMISSION)
The indicator will come on when the Power
mode (P) switch near the gear selector le-
ver is selected.
Use this mode if you need more power dur-
ing abrupt acceleration, driving on steep hills.
At this time, gear shifting time delays than
normal to get more traction power.
Your vehicle was designed in compliance
with European On Board Diagnostic (EOBD)
requirements which were specified by Eu-
ropean Economic Community Directive.
The engine check indicator will illuminate if
a fault exists in the emission related compo-
nents or related sub systems.
It will stay on as long as the Engine Control
Unit (ECU) detects the fault.
If a severe misfire is detected, fuel is cut
automatically to avoid catalytic converter
damage.
Your vehicle’s electronic system will switch
to an emergency running program so you
may continue to drive.
However, you should consult a Ssangyong
Distributor or Ssangyong Authorized Service
Operation to repair the problem as soon as
possible.
CAUTION
Do not drive with the engine check
indicator lamp on.
The indicator lamp signals that your
vehicle has a problem that requires
attention.
Driving with the engine check indi-
cator lamp on can damage the emis-
sions control system and can affect
the fuel economy and drivability or
your vehicle.
Consult a Ssangyong distributor or
a Ssangyong Authorized Service
Operation to repair the problem as
soon as possible.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 10 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
