INSTRUMENTS AND CONTROLS 3–29
HEADLIGHT LEVELING SWITCH*
With the low beam switched on, adjust the
aiming angle of headlights to suit the vehicle
load.
• To lower the aiming angle, push the
switch downward.
• To raise the aiming angle, push the
switch upward.
CAUTION
Wiper operation on dry windshield
can scratch glass and wear the
blades prematurely.
Do not operate wipers when wind-
shield is dry.
WINDSHIELD WIPER SWITCH
To operate the windshield wipers, move the
lever in 3 downwards steps with the igni-
tion on.
OFF = Off
AUTO = Operates automatically according to
the vehicle speed or amount of rain (rain
sensor equipped vehicle)
LO = Continuous wipe, slow speed
HI = Continuous wipe, fast speed
CAUTION
Wiper operation with obstructions,
such as snow, can damage wiper
motor.
Clear obstruction before operating.
CAUTION
Wiper blades can freeze to wind-
shield in cold weather.
Wiper operation while the blades are
frozen can damage the wiper motor.
Check blades are not frozen to wind-
shield before operating.
NOTE
According to load condition, adjust
the aiming angle of headlights.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 29 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
