8–34 SERVICE AND MAINTENANCE
14. Tighten the wheel nuts firmly according
to sequence No. of above figure.
15. Check and adjust tyre pressure.
16. Secure the jack and tools in their proper
locations.
17. Secure the flat tyre in the spare tyre
well.
CAUTION
•
If over tightened, the wheel nuts
could be damaged. Do not over
tighten the wheel nuts by pressing
the wheel nut wrench by foot or
using assist pipe.
•
Do not completely tighten a wheel
nuts at a time. Tighten it with sev-
eral times in a crisscross sequence.
•
Never use oil or grease on wheel
nuts.
•
Always use the correct wheel nuts.
Rear Jack up point
12. Replace and lightly seat the wheel nuts
by turning clockwise.
13. Turn jack connection rod counter-clock-
wise and lower vehicle to the ground.
CAUTION
Do not attempt to raise vehicle until
the jack is in the proper position,
and secure both to the vehicle and
the ground.
New Rexton08_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:38Page 34 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
