INSTRUMENTS AND CONTROLS 3–25
• To see the difference of the altitude
Set the vehicle’s altitude to 0 by press-
ing UP and DOWN switches simulta-
neously over 1 second. read the in-
dicated altitude after arrival.
Use this to see the specific area’s altitude;
it shows the specific area’s relative altitude
based on the current altitude of the vehicle.
Mode setting of the relative altimeter
1. Press the MODE switch over 1 second.
X Indication type
RELATIVE ALTIMETER
• To see the destination’s altitude
1. Enter the altitude of the point where you
know the altitude from the sea level.
2. The indicated value on the destination is
the altitude from the sea level.
CAUTION
The altimeter operates by using
changes of atmospheric pressure.
So, sometimes, the indicated altitude
may different due to changing atmo-
spheric pressure in the same place,
however, it is normal, not
malfunctions.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 25 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
