3–40 INSTRUMENTS AND CONTROLS
Operating Memory Settings
1. Place the selector lever in “P” position
(Automatic transmission) or apply the
parking brake with the ignition switch
“ON”.
2. Keep the position button pushed (for
more than 1.5 second) until driver’s seat
and outside rearview mirrors start to
move.
3. If you press the button driver’s seat
outside rearview mirrors will be recalled
automatically to the memory positions.
CAUTION
•
To recall the memory positions,
press the position button for more
than 1.5 second.
•
If you press “STOP” button or op-
erate only one switch among the
switches in order to adjust the
driver’s seat outside rearview mir-
rors, recalling of the memory po-
sitions will be stopped.
SEAT POSITION MEMORY
SETTING AND OPERATION*
1. “SET” Switch
2. “STOP” Switch
3. Position Switch
Up to 3 different drivers, the memory set-
ting of seat position is available. Each driver
can set his/her own driver’s seat and out-
side rearview mirrors positions and it will be
stored in the computer. Even if someone
have moved your seat and outside rearview
mirrors, the memory positions will be recalled
automatically by pressing the position button.
Storing Memory Settings
1. Place the selector lever in “P” position
(Automatic transmission) or apply the
parking brake with the ignition switch
“ON”.
2. Adjust the driver’s seat and outside rear-
view mirrors.
3. Press the “SET” button. Indicating light
on the button will come on and beep
sounds.
4. Within five seconds, press button you
want among 1,2 or 3 of the position
buttons. Adjusted positions will be stored
in the computer with “Beep”. sound.
CAUTION
•
Never operate the driver’s seat and
outside rearview mirror switch
during memory settings, or
memory setting will be cancelled.
•
If you do not press the position
button within 5 seconds after
pressing the “SET” button, memory
setting will be cancelled.
•
Memory settings are possible up to
3 different drivers.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:31Page 40 Adobe PageMaker 6.5K/Win