To Next Page

To Previous Page

Quick start UM1724

8/55 DocID025833 Rev 4

3 Quick start

The STM32 Nucleo board is a low-cost and easy-to-use development platform used to

quickly evaluate and start a development with an STM32 microcontroller in LQFP64

package.

Before installing and using the product, please accept the Evaluation Product License

Agreement from www.st.com/stm32nucleo.

For more information on the STM32 Nucleo boards and to access the demonstration

software, visit www.st.com/stm32nucleo.

3.1 Getting started

Follow the sequence below to configure the STM32 Nucleo board and launch the demo

software:

1. Check the jumper position on the board, JP1 off, JP5 (PWR) on U5V, JP6 on (IDD),

CN2 on (NUCLEO) selected.

2. For correct identification of all device interfaces from the host PC, install the Nucleo

USB driver available on www.st.com/stm32nucleo, prior to connecting the board

3. Connect the STM32 Nucleo board to a PC with a USB cable ‘type A to mini-B’ through

USB connector CN1 to power the board. The red LED LD3 (PWR) and LD1 (COM)

should light up. LD1 (COM) and green LED LD2 should blink.

4. Press button B1 (left button).

5. Observe how the blinking of the green LED LD2 changes according to clicks on button

B1.

6. The demo software and several software examples on how use the STM32 Nucleo

board features are available on www.st.com/stm32nucleo.

7. Develop your own application using the available examples.

3.2 System requirements

• Windows PC (XP, Vista, 7, 8)

• USB type A to Mini-B USB cable

ST STM32 Nucleo board User Manual

Questions and Answers: