ST STM32 NUCLEO-F303K8 - Hardware Layout and Configuration

DocID028406 Rev 1 11/31
UM1956 Hardware layout and configuration
30
6 Hardware layout and configuration
The Nucleo-32 board is based on a 32-pin STM32 microcontroller in LQFP or UFQFPN
package.
Figure 2 illustrates the connections between the STM32 and its peripherals (ST-LINK/V2-1,
push button, LED, and Arduino Nano connectors).
Figure 3: Top layout view of the Nucleo-32 board and Figure 4: Bottom layout view of the
Nucleo-32 board show the location of these features on the Nucleo-32 board.
Figure 2. Hardware block diagram
06Y9
(PEHGGHG
67/,1.9
670
0LFURFRQWUROOHU
5(6(7
0LFUR
86%
,2
,2
%
567
$UGXLQR1DQR
FRQQHFWRU
/('
/'
$UGXLQR1DQR
FRQQHFWRU