ST STM32 Nucleo-32 - User Manual

November 2018 UM1956 Rev 5 1/37
1
UM1956
User manual
STM32 Nucleo-32 boards (MB1180)
Introduction
The STM32 Nucleo-32 boards based on the MB1180 reference board (NUCLEO-F031K6,
NUCLEO-F042K6, NUCLEO-F301K8, NUCLEO-F303K8, NUCLEO-L011K4, NUCLEO-
L031K6, NUCLEO-L412KB, NUCLEO-L432KC) provide an affordable and flexible way for
users to try out new concepts and build prototypes with STM32 microcontrollers, choosing
from the various combinations of performance, power consumption and features. The
Arduino™ Nano connectivity support makes it easy to expand the functionality of the
Nucleo-32 open development platform with a wide choice of specialized shields. The
STM32 Nucleo-32 boards do not require any separate probe as they integrate the ST-
LINK/V2-1 debugger/programmer and come with the STM32 comprehensive software HAL
library, together with various packaged software examples, as well as direct access to the
Arm
®
Mbed™ online resources at http://mbed.org.
Figure 1.
STM32 Nucleo-32 board
Picture is not contractual.
www.st.com

ST STM32 Nucleo-32 Specifications

General

Microcontroller	STM32
Pin Count	32
Connectivity	USB
Debugging	ST-LINK/V2-1
Core	ARM Cortex-M
Operating Voltage	3.3V
Power Supply	USB or External Source
Clock Speed	Varies by specific STM32 MCU
Flash Memory	Varies by specific STM32 MCU
SRAM	Varies by specific STM32 MCU
GPIO Pins	Varies by specific STM32 MCU
ADC	Varies by specific STM32 MCU
DAC	Varies by specific STM32 MCU
Communication Interfaces	I2C, SPI, USART, USB
Expansion Connectors	Arduino Nano connectivity
Operating Temperature	Varies by specific STM32 MCU

Summary

Features

Ordering Information

Quick Start

Getting Started

Guide to configure and launch the demonstration software on the STM32 Nucleo-32 board.

System Requirements

Lists the necessary software and hardware for using the STM32 Nucleo-32 board.

Hardware Layout and Configuration

STM32 Nucleo-32 Board Layout

Embedded ST-LINK;V2-1 Drivers

Information on installing necessary USB drivers for the ST-LINK/V2-1 debugger.

ST-LINK;V2-1 Firmware Upgrade

Power Supply and Power Selection

Overview of powering options for the STM32 Nucleo-32 board.

Power Supply Input from USB Connector

External Power Supply Inputs

Explains how to connect external power sources like VIN, +5V, and +3V3.

USART Virtual Communication

Solder Bridges

Arduino Nano Connectors