To Next Page

To Previous Page

UM1956 Rev 5 9/37

UM1956 Quick start

5 Quick start

The STM32 Nucleo-32 board is a low-cost and easy-to-use development kit used to quickly

evaluate and start a development with an STM32 microcontroller in LQFP32 or UFQFPN32

package.

Before installing and using the product, accept the Evaluation Product License Agreement

that can be found at www.st.com/epla.

For more information on the STM32 Nucleo-32 board and to access the demonstration

software, visit the www.st.com/stm32nucleo webpage.

5.1 Getting started

Follow the sequence below, to configure the STM32 Nucleo-32 board and launch the

demonstration software:

• Check solder bridge position on the board, SB1 OFF, SB14 ON (internal regulator), JP1

ON (IDD) selected.

• For a correct identification of all device interfaces from the host PC and before

connecting the board, install the Nucleo USB driver, available at the

www.st.com/stm32nucleo webpage.

• To power the board connect the STM32 Nucleo-32 board to a PC through the USB

connector CN1 with a USB cable Type-A to Micro-B. The red LED LD2 (PWR) and LD1

(COM) light up and green LED LD3 blinks.

• Remove the jumper placed between D2 (CN3 pin 5) and GND (CN3 pin 4).

• Observe how the blinking frequency of the green LED LD3 changes, when the jumper

is in place or when it is removed.

• The demonstration software and several software examples on how to use the STM32

Nucleo-32 board features, are available at the www.st.com/stm32nucleo webpage.

• Develop an application using the available examples.

5.2 System requirements

• Windows

OS (7, 8 and 10), Linux

64-bit or macOS

®(a)

• USB Type-A to Micro-B USB cable

a. macOS

is a trademark of Apple Inc. registered in the U.S. and other countries.

ST STM32 Nucleo-32 User Manual

Questions and Answers: