ST STM32L053 - Revision History; Table 9. Document Revision History

Revision history UM1775
38/39 UM1775 Rev 4
Revision history
Table 9. Document revision history
Date Revision Changes
20-Jun-2014 1 initial release
24-Jun-2014 2 Removed embedded USB bootloader paragraph.Rev 4
20-Jan-2016 3
mbed-enabled logo added on the cover page.
Added mbed-enabled in Section 3: Features.
Added Section 2.1: Product marking
Windows Vista removed from Section 4.1.1: Drivers.
SB14, SB15 swapped with SB2, SB3 in Table 5: Solder
bridges, default position of SB2,SB3 set to ON and
ports modified from PB4, PB3 to PA10, PA9.
Added Section 4.1.3: VCP configuration
10-Sep-2021 4
Removed Electrical schematics and Demonstration
software.
Added Chapter 8: 32L0358DISCOVERY Discovery kit
information, Appendix A: Federal Communications
Commission (FCC) and ISED Canada Compliance
Statements and Appendix B: CE conformity.
Updated Section 6.1: Embedded ST-LINK/V2-1,
Section 6.6: Electronic paper display (EPD) and
Section 6.9: Linear touch sensor / touchkeys.
Updated Figure 2: STM32L053 Discovery board
hardware block diagram and Figure 3: Top layout.
Revised the beginning of the document:
– Updated Introduction, Section 1: Features,
Section 2: Ordering information, Section 3.1: System
requirements, Section 3.2: Development toolchains
and Section 5.1: Getting started
– Added Section 2.1: Codification