EasyManua.ls Logo

STA-RITE ALB - User Manual

STA-RITE ALB
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER’S MANUAL
Convertible Deep Well Jet Pumps
NOTICE D’UTILISATION
Pompe à éjecteur transformables
pour puits profonds
MANUAL DEL USUARIO
Bombas Convertibles tipo “Jet”
para Pozos Profundos
Installation/Operation/Parts
For further operating, installation, or
maintenance assistance:
Call 1-262-728-9181
English . . . . . . . . . . . . . . Pages 2-12
Installation/Fonctionnement/Pièces
Pour plus de renseignements
concernant l’utilisation,
l’installation ou l’entretien,
Composer le
1 (262) 728-9181
Français . . . . . . . . . . . Pages 13-23
Instalación/Operación/Piezas
Para mayor información sobre el fun-
cionamiento, instalación o
mantenimiento de la bomba:
Llame al 1-262-728-9181
Español . . . . . . . . . . .Paginas 24-34
1859 0795
S367 (Rev. 5/5/09)
293 Wright Street, Delavan, WI 53115

Table of Contents

Questions and Answers

  • M
    moniquelunaAug 2, 2025
    What to do if my STA-RITE ALB Water Pump runs but no water comes out?
    • M
      Michael MorganAug 2, 2025
      First, ensure the STA-RITE Water Pump is primed by checking that the pump, suction piping, and well piping are full of water. If they aren't, fill them. In cold weather, check for frozen pipes and thaw them carefully to avoid splits. Consider heating the pump pit or pump house and burying pipes below the frost line. Other possible causes: air leaks in the suction line, dropping water level in the well, foot valve stuck or plugged, ejector plugged, impeller plugged, foot valve or strainer stuck in the mud in the bottom of the well, a shallow well pump installed on a well with more than 25 ft depth to water (in this case a deep well jet pump is needed).
  • B
    Bernard GillAug 6, 2025
    How to troubleshoot a STA-RITE ALB Water Pump motor that will not run?
    • H
      harrismartinAug 6, 2025
      Verify the disconnect switch is ON and that the circuit breaker hasn't tripped or the fuse hasn't blown. Disconnect the power and ensure that the wires connecting the motor to the power supply and pressure switch are tight and correctly connected.
  • R
    Ryan ChanAug 10, 2025
    Why does my STA-RITE ALB Water Pump cycle too frequently?
    • D
      Denise HendersonAug 10, 2025
      First, check that no faucets are left open. If your system uses a standard tank, ensure it isn't waterlogged; if it is, drain it to the air volume control level. Verify the AVC functions correctly and that all connections are leak-free. For precharged tanks, disconnect power, open all faucets, and bleed the tank pressure. Use a tire gauge to check the air pressure; it should be 2 PSI lower than the pressure switch's cut-in setting (e.g., 28 PSI if the switch starts at 30 PSI). Check the air valve for leaks using a soap solution and replace the core if needed.
  • C
    Christina TorresAug 14, 2025
    Why does my STA-RITE Water Pump motor run hot and trip the overload?
    • S
      sanchezdanielAug 14, 2025
      Verify the motor is correctly wired according to the electrical instructions. Ensure the voltage at the pump is within + 10% of the motor’s rated nameplate voltage. Disconnect the power and make sure the wires connecting the motor to the power supply are sized appropriately. If the pump is cycling too frequently, refer to Section E.
  • K
    Kimberly JohnsonAug 19, 2025
    What causes a STA-RITE Water Pump not to deliver water to full capacity?
    • J
      Jasmine RileyAug 19, 2025
      Possible causes are: the well water level is lower than estimated, making a different nozzle/venturi combination necessary; steel piping (if used) is corroded or limed, restricting capacity and increasing friction; or the piping is too small for the installation.
  • O
    oyoungAug 23, 2025
    Why is there air spurting from the faucets when using my STA-RITE ALB Water Pump?
    • H
      Heather PriceAug 23, 2025
      The STA-RITE Water Pump may still be priming; once priming is complete, all air should be ejected from the system.
  • K
    kperkinsAug 28, 2025
    What to do if STA-RITE ALB leaks around the clamp?
    • E
      Elizabeth GrayAug 28, 2025
      Tighten the clamp nut 1-2 turns, but be careful not to overtighten it.

Summary

Convertible Deep Well Jet Pumps

Safety

Electrical Safety

Safety precautions for electrical components and wiring.

General Safety

General safety guidelines for pump operation and maintenance.

Typical Installations

Drive and Suction Functions

Explains how the drive and suction pipes work.

Reversed Connections to Well

Illustrates alternative pipe connections to the well head.

Mount Ejector - Shallow Well

Details mounting the ejector for shallow well applications.

Typical Deep Well Installations

Diagrams of deep well pump system configurations.

Typical Shallow Well Installations

Diagrams of shallow well pump system configurations.

Discharge Pipe and Pressure Tank Connections

Pre-Charge Tank Connection

Instructions for connecting a pre-charged pressure tank.

Standard Tank Connection

Instructions for connecting a standard pressure tank.

Electrical

Motor Switch Settings

How to adjust motor settings for different voltages.

Plug Type Voltage Selector

Guide for using the plug-type voltage selector.

Dial Type Voltage Selector

Guide for using the dial-type voltage selector.

Wiring Connections

Steps and precautions for connecting pump wiring.

Connection Procedure

Detailed steps for making electrical connections.

Preparing to Start the Pump - Deep Well

Fill Pump

Step to fill the pump with water before starting.

Prime Pump

Step to prime the pump and remove air.

Set Control Valve

Adjusting the control valve for efficient operation.

Preparing to Start the Pump - Shallow Well

Open Control Valve

Step to open the control valve for shallow well priming.

Repair Parts

Service Kits

List of available service and overhaul kits.

Cast Iron Jet Pump Parts

Part numbers and descriptions for cast iron jet pumps.

Corrosion Resistant Jet Pump Parts

Part numbers and descriptions for corrosion resistant jet pumps.

Troubleshooting

Motor Will Not Run

Steps to diagnose and fix a motor that fails to start.

Motor Runs Hot and Overload Trips

Solutions for overheating motors and tripping overloads.

Motor Runs But No Water Delivered

Troubleshooting no water delivery issues.

Pump Does Not Deliver Water to Full Capacity

Diagnosing issues with reduced pump capacity.

Pump Cycles Too Frequently or Does Not Shut Off

Addressing frequent pump cycling or failure to shut off.

Air Spurts from Faucets

Identifying causes of air in water lines.

Pump Leaks Around Clamp

How to fix leaks around pump clamps.

STA-RITE ALB Specifications

General IconGeneral
BrandSTA-RITE
ModelALB
CategoryWater Pump
LanguageEnglish

Related product manuals