Stabila LAR-200 - Replacing the batteries; Operating status display and error messages via the LEDs; LED indicators and error messages

12
Unfasten the catch on
the battery compartment
cover: remove the cover
and the batteries. Insert
new batteries following
the instructions in the
battery compartment.
Only use 1.5V mono cells
(size D)!
Replacing the batteries
Operating status display and error messages
via the LEDs
Illuminated green LED
-> The laser levels itself automatically
-> laser in operation
-> laser in operation
-> battery voltage very low
-> battery replacement required imminently
-> Battery voltage very low
-> The unit is inclined too much
+ is outside the self-levelling range
+ the laser cannot level itself automatically
Illuminated green LED +
laser beam flashing
Illuminated red LED
Flashing red LED
+ laser beam flashing
-> The unit is inclined too much
+ is outside the self-levelling range
+ the laser cannot level itself automatically
Flashing green LED
+ laser beam flashing
-> The laser levels itself automatically
-> Battery voltage very low
-> Battery replacement required imminently
Illuminated red LED
+ laser beam flashing
Tip:
Remove the batteries if the unit will not be used for a long period !
Mono, D , LR20
7
1.
2.