Stack-On GCG-8RTA - User Manual

Tools Required: Phillips screwdriver, 7/16” socket wrench, drill, 3/16” drill bit,
adjustable wrench
Keep keys in a secure place away from children.
Do not store this document in the cabinet
Portable Case
4327-1309
18
1
Instructions
GCG-8RTA
GCB-8RTA
HELPFUL HINTS
ASSEMBLING THE CABINET
WARNING
Tip Over Hazard
A child or adult can tip the cabinet and be killed or
seriously injured.
Failure to secure the cabinet as shown in these
instructions can result in death or serious injury to
children and adults.
Children should not play with or around the
cabinet at any time.
Carriage bolt
Lock washer
Back panel
Side
panel
Side
panel
Nylon locking nut
Figure 1
2. Keep the assembly standing up as shown. Locate the boom panel
(the one without the nameplate) and place it on the sides and back
assembly. e front and back anges of this panel must be on the
outside of the cabinet. (See gure 2) e side anges will be on the
inside of the cabinet.
Assemble with (10) carriage bolts, lock washers and nylon locking
nuts. Hand tighten the bolts at this time.
Now turn the entire unit over to prepare for assembling the shelf and
top.
1. Assemble the side panels to the back panel.
For the entire assembly of the cabinet body, the heads of all the
carriage bolts will be on the outside of the cabinet.
For easy assembly, stand the panels up as shown. Assemble each side
with (6) carriage bolts, locking washers and nylon locking nuts. Hand
tighten the bolts at this time. (See Figure 1)
For easier assembly, follow the exact sequence of assembly steps shown
in the following pages.
A small socket wrench with a 7/16" (11mm) socket is the best way to
tighten the interior nylon locking nuts. Hold the head of the carriage
bolt in the square holes of the cabinet while tightening the bolts. Do
not over tighten these bolts.
When assembling the cabinet body, only hand tighten the bolts until all
the parts are assembled. is will make it easy to align all the holes.
Serial #:
Key #:
NOTE: You can store your Key # and your Serial # information on
Stack-On’s SECURE web site – www.stack-on.com under Service.
Storing your Key # will provide instant access to this important
information, should you ever lose your keys or need the number to
order a new set.
Only you will have access to this information.
Front flange
Back
flange
Bottom panel
Figure 2
Record the key number and serial number from the back of the cabinet.
IMPORTANT:

Stack-On GCG-8RTA Specifications