Stamina 1205 PRECISION ROWER - Load Adjustment and Storage; Routine Maintenance Procedures

1. To store the 1205 PRECISION ROWER, simply keep it in a clean dry place.
2. Grasp the Front and Rear Stabilizer to move the 1205 PRECISION ROWER. Do not use the Seat to
move the 1205 PRECISION ROWER. The Seat will move and the Seat Carriage may pinch your hand
or ngers.
3. To avoid damage to the electronics, remove the battery before storing the 1205 PRECISION ROWER
for one year or more.
The safety and integrity designed into the 1205 PRECISION ROWER can only be maintained when the
1205 PRECISION ROWER is regularly examined for damage and wear. Special attention should be
given to the following:
STORAGE
MAINTENANCE
12
NOTE:
Tighten LOCKING KNOBS(10) securely before
using the 1205 PRECISION ROWER.
CAUTION:
The SHOCKS(11) get HOT after a few minutes of
use. To avoid burns, do not touch the shock until it
has time to cool.
OPERATIONAL INSTRUCTIONS
LOAD ADJUSTMENT
The resistance of the shocks can be adjusted by sliding the TENSION ADJUSTERS(9) to change the position
on the HANDLEBARS(5, 6). The lowest position will provide the lowest resistance, the upper position will
provide the higher resistance.
Loosen the LOCKING KNOB(10) and slide the TENSION ADJUSTER(9) to aspired position. Tighten the
LOCKING KNOB(10) after adjusting. Use the number marks on the HANDLEBARS(5, 6) to help set the
TENSION ADJUSTER(9) at the same height on
both sides.
1. Pull on the HANDLEBARS(5, 6) and verify that the SHOCKS(11) provide tension.
2. Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.
3. Verify that the CAUTION LABEL(53) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(53) if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Verify that that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
6. Worn or damaged components shall be replaced immediately or the 1205 PRECISION ROWER
removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the 1205 PRECISION
ROWER.
8. Keep your 1205 PRECISION ROWER clean by wiping it off with an absorbent cloth after use.