1. To store the AVARI® Programmable Stepper, simply keep it in a clean dry place.
2. The AVARI® Programmable Stepper is approximately 38.8 inches long x 39 inches wide x 59 inches
tall. These dimensions will vary. Please measure your AVARI® Programmable Stepper if exact
dimensions are needed.
3. To move the AVARI® Programmable Stepper, lift the REAR STABILIZER(3) and use the
WHEELS(31) on the front stabilizer.
The safety and integrity designed into the AVARI® Programmable Stepper can only be maintained
when the AVARI® Programmable Stepper is regularly examined for damage and wear. Special
attention should be given to the following:
1. Use the UP, DOWN, and ENTER buttons on the COMPUTER(71) to select a program and verify that
the MAGNETIC SYSTEM(7) provides different tensions. The Magnetic System should provide many
years of use.
2. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
3. Verify that the WARNING LABEL(87) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(87) if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the AVARI® Programmable Stepper
removed from service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the AVARI®
Programmable Stepper.
7. Keep your AVARI® Programmable Stepper clean by wiping it off with an absorbent cloth after use.
STORAGE
MAINTENANCE
22
To Next Page
Loading...
