The safety and integrity designed into the BioFLEX 1700 can only be maintained when the BioFLEX
1700 is regularly examined for damage and wear. Special attention should be given to the following:
1. Verify that the WARNING LABEL(72) and LAT BAR WARNING LABEL(73) are in place and
easy to read. Call Stamina Products immediately at 1-800-375-7520 for a replacement WARNING
LABEL(72) if it is missing or damaged.
2. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
3. Worn or damaged components shall be replaced immediately or the BioFLEX 1700 removed from
service until repair is made.
4. Verify that the Cables are properly installed on all Pulleys.
5. Check the condition of the Cables. Replace the Cables if the plastic coatings are cracked or broken.
6. Check the Tension Cords for wear. Replace Tension Cords that are frayed or worn.
7. Check the plastic hooks on the both ends of all Tension Cords. Replace Tension Cords with deformed
or damaged hooks.
8. Check the pulleys for excessive wear. Replace worn pulleys.
9. Only Stamina Products supplied components shall be used to maintain/repair the BioFLEX 1700.
10. Keep your BioFLEX 1700 clean by wiping it off with an absorbent cloth after use.
STORAGE
MAINTENANCE
23
1. To store the BioFLEX 1700, simply keep it in a clean dry place.
2. To move the BioFLEX 1700, hold the upright of the BioFLEX 1700 while you tip it backward. When
the WHEELS(32) come in contact with the oor you can easily roll the BioFLEX 1700.
To Next Page
Loading...
