Standard PF-P330 - No Feeding Occurs Frequently

39
No Feeding Occurs Frequently
No Feeding Occurs Frequently
Raise the gate plate height
adjusting lever to lower the
gate plate.
Is gate plate position too high?
Remedy
Check
Is table height not too low?
Lower the table height
adjusting lever to raise
the table height.
Remedy
Check
L
0
H
Troubleshooting
A
B
L
H
0
A
B
Set the guide loose so that the piled sheets moves lightly.
Are sheet guides not set too tight?
Remedy
Check
Is used sheet too thick, or too heavy.
Use the sheets within specification.
Remedy
Check
The pump is worn.
Pump is worn by about 1,000 hours of use. Please call your local dealer to
replace the pump.
Remedy
Cause
When the no feeding occurs frequently, there are various causes. Check the cause one by one
and perform the test folding to solve the problem.
Refer to page 52.
Strengthen the air setting.
1. Press the mode selecting button inside the extension panel to show
[Air] on the display.
2. Press stopper 2 moving button (Upper) to strengthen the air setting.
3. Press the mode selecting button once.
- The setting will be entered and the counter appears on the display.
Is air setting too weak?
Remedy
Check
1
2
3
4
5
6
7
89
0
C
Feed Gap
2 nd
Stopper
1 st
Stopper
Memory
Mode
Stopper
Position
Display
Air
Stopper 2 Moving Button (Upper)
Table Height
Adjusting Lever
Gate Plate Height
Adjusting Lever
Mode Selecting Button