8 DH USER MANUAL
• The operator must not operate the tool or carrier if any people are within the area where they may be injured by ying
debris or movement of the equipment.
• Know the limits of your equipment.
• Establish a training program for all operators to ensure safe operation.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor.
• Become familiar with the carrier controls before operating the carrier and the tool.
• When operating the tool you must use ear protection, eye protection, and breathing protection.
• While learning to operate the tool and carrier, do so at a slow pace. If necessary, set the carrier mode selector to the
slow position.
• Make sure all controls (levers and pedals) are in the NEUTRAL position before starting the carrier.
• While operating the tool and carrier, keep hands and feet on the controls at all times.
• Before leaving the carrier, always lower the boom and insure the carrier is stable. Never leave the machine with the
engine running. ALWAYS ENGAGE THE PARKING BRAKE.
• Stop the engine before attempting to make any repairs, adjustments or servicing to either the carrier or the tool.
• Do not operate the tool at oil temperatures above 190°F/88°C. Operation at higher temperatures can damage the internal
components of the equipment and will result in reduced performance.
• Do not operate a damaged, leaking, improperly adjusted, or incompletely assembled tool.
• Do not modify the tool in any manner.
• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by
authorized and properly trained personnel.
• If you do not understand how to safely operate your tool, contact an authorized Stanley Dealer for assistance.
• Keep this manual with the tool.
• Do not operate this equipment if you are taking medication which may affect your mental judgement or physical
performance.
• Do not operate this equipment if you are under the inuence of drugs or alcohol.
• Replace all faulty or leaking hydraulic hoses before further operation.
• After operation, hydraulic components may be hot enough to burn skin.
SAFETY PRECAUTIONS
To Next Page
Loading...
