Stanley Dura-Glide Series - Door System Operation; Function Switches Explained; Emergency Breakout Procedure; Manual Reset Steps

4
Operation

FunctionSwitches:

Thefunctionswitchesforthedooroperatorarelocatedontheundersideofthedoor
headeroronthejambofthestationarypanel(seediagram).Thefunctionswitches
are:
x PowerSwitch–thisswitchisilluminatedaredcolorwhenthepowerison.
Thisswitchshouldnotbeturnedoffunlessthedoorisbeingserviced.
x Auto/Close/OpenSwitch–thisisa3‐positionswitchthatallowsthedoorto
functionautomatically(auto);stayclosedandnotfunctionatall,butremain
secure(close);orholdopenindefinitely(open).
x Enterswitch–Ifthe“one‐way”featureisinstalled,thisswitchwillchange
themodeofthedoorsothatitwillnotopenfromtheoutsidewhenthedoor
isfullyclosed
x ReducedOpeningSwitch–ifthe“ReducedOpening”featureisinstalled,this
switchwillcausethedoortoopenpartiallywhenactivated.

EmergencyBreakout:

Incaseofpowerfailureorotheremergency,ourslidingdoors“breakout”toprovideawideopening,
soyou’realwaysassuredofaclearexit.Dependingonyourmodel,thenumberofpanelsthatbreakout
varies.

Breakoutmeansthatifyoupushtheleadingedgeoftheslidingpaneloutward,asyouwouldaswing
door,thepanelwillunlatchandpivotoutwards.Thiscanbedoneatanypointofthedoor’snormal
slidepath.Ifthedoorsarebrokenout,thereisaswitchthatwilldisableautomaticoperation.The
doorswillnotfunctionautomaticallyunlessthepanelsarereturnedtotheirnormal,operating
position.

Reset:
Ifthedoorsystemlosespowerforanyperiodoftime,thecontrollerintheheaderwillhaveto
reinitialize.Initializationthedoorwilloccurautomaticallyduringthefirstcycleofoperationwhen
powerisrestoredandthedoorisnotphysicallylocked.Thestepsforamanualresetareasfollows:

1. Turn“POWER”switchto“OFF”position(non‐illuminated)
2. Verifythatnoneofthepanelsare“brokenout”.(notalignedindoortrack)
3. Turn“AUTO/CLOSE/OPEN”switchto“AUTO”position.
4. Turn“POWER”switchto“ON”.
5. Stepbackasdoorsre‐tunetonormaloperation.
