EasyManuals Logo

Stanley FATMAX V20 User Manual

Stanley FATMAX V20
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
6
ENGLISH
ADDITIONAL SAFETY INSTRUCTIONS FOR
GRASS TRIMMERS
WARNING: Cutting elements continue to
rotate after the motor is switchedoff.
Wear long trousers to protect yourlegs.
Before using the appliance, check that your cutting path is free
from sticks, stones, wire and any otherobstacles.
Only use the appliance in the upright position, with the cutting
line near the ground. Never switch the appliance on in any
otherposition.
Move slowly when using the appliance. Be aware that freshly
cut grass is damp andslippery.
Do not work on steep slopes. Work across the face of slopes,
not up anddown.
Never cross gravel paths or roads while the appliance
isrunning.
Never touch the cutting line while the appliance isrunning.
Do not put the appliance down until the cutting line has come
to a completestandstill.
Use only the appropriate type of cutting line. Never use metal
cutting line or fishingline.
Keep hands and feet away from the cutting line and blade at
all times, especially when switching on themotor.
Before using the appliance and after any impact, check for
signs of wear or damage and repair asnecessary.
Take care against injury from any device fitted for trimming
the filament line length. After extending new cutter line always
return the machine to its normal operating position before
switchingon.
Close supervision is necessary when the appliance is used
nearchildren.
This appliance is not intended for use by young or infirm
persons withoutsupervision.
This appliance is not to be used as atoy.
Use in a dry location only. Do not allow the appliance to
becomewet.
Do not immerse the appliance inwater.
Do not open the body casing. There are not user-serviceable
parts inside
Do not operate the appliance in explosive atmospheres, such
as in the presence of flammable liquids, gases ordust.
When the appliance is stored or transported in a vehicle
it should be placed in the boot or restrained to prevent
movement following sudden changes in speed ordirection.
When not in use, the appliance should be stored in a dry, well
ventilated place out of reach ofchildren.
Children should not have access to storedappliances.
Safety of Others
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for theirsafety.
Children must be supervised to ensure that they do not play
with theappliance.
Residual Risks
To ensure you have good footing on slopes, do not overreach.
Keep your balance at all times. Always walk, do notrun.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged useetc.
Even with the application of the relevant safety regulations and
the implementation of safety devices, certain residual risks can
not be avoided. These include:
Injuries caused by touching any rotating/movingparts.
Injuries caused when changing any parts, blades
oraccessories.
Injuries caused by prolonged use of a tool. When using any
tool for prolonged periods ensure you take regularbreaks.
Impairment ofhearing.
Health hazards caused by breathing dust developed when
using your tool (example: working with wood, especially oak,
beech and MDF.)
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of yourmains.
Your STANLEYFATMAX charger is double insulated
in accordance with EN60335; therefore no earth wire
isrequired.
WARNING: 115 V units have to be operated
via a fail-safe isolating transformer with an earth screen
between the primary and secondary winding.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the STANLEYFATMAX
serviceorganisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
Safely dispose of the oldplug.
Connect the brown lead to the live terminal in theplug.
Connect the blue lead to the neutralterminal.
WARNING: No connection is to be made to the
earthterminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3A..
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stanley FATMAX V20 and is the answer not in the manual?

Stanley FATMAX V20 Specifications

General IconGeneral
Battery Voltage18V
Line Diameter1.6 mm
Battery TypeLithium-Ion
Line FeedAutomatic
Variable SpeedYes
Power SourceBattery
RuntimeUp to 40 minutes

Related product manuals