Stanley ID07 - Page 12

12 ► ID07 User Manual
To prevent damage to the retaining ring, do not
attempt to force the selector screw counter-clockwise
beyond the point of initial resistance.
Reinstall the hex plug. Failure to install the plug may introduce contaminants to the spool bore resulting in replacement
of the valve spool and main housing.
INSERT TOOL BIT - FIG. 3
1.
Always use sockets and accessories designed
for impact type applications and that are in good
condition. DO NOT USE STANDARD SOCKETS
& ACCESSORIES OR SOCKETS THAT ARE IN
POOR CONDITION. THESE CAN CRACK OR
FRACTURE DURING OPERATION AND CAN
BECOME A PROJECTILE.
Disconnect the tool from the hydraulic power source.
2. Push back on the tool retaining sleeve.
3. Insert the tool bit and lock the tool retaining sleeve in
place.
Note: Never use the tool if the bit is not locked in the
tool retainer.
CONNECT HOSES
1. Wipe all hose couplers with a clean, lint-free cloth before making connections.
2. Connect hoses from the hydraulic power source to the tool ttings or quick disconnects. Connect the return
hose rst and disconnect it last to minimize or eliminate trapped pressure within the wrench.
3. Observe the ow indicators stamped on the main body assembly and the hose couplers to ensure that the ow
is in the proper directions. The female couple on the tools “IN” port is the inlet (pressure) coupler.
Note: If the uncoupled hoses are left in the sun, pressure increase within the hoses can make them di󰀩cult
to connect. Whenever possible, connect the free ends of hoses together.
WRENCH OPERATION
The ID07 is designed for 1/2-inch square or 7/16-inch hex drive.
During normal operation it is common to see some grease leakage from around the anvil during hard use. Refer to
the Service Manual for the correct lubrication procedures.
1. Observe all Safety Precautions.
2. Move the hydraulic circuit control valve to the “ON” position to operate the wrench.
3. Select the direction (clockwise or counterclockwise) of impact desired by pushing the reversing spool either left
Figure 3 - Install the Tool Bit
2
3
OPERATION