Stanley Omnilock 45HOM User Manual

Installation Instructions for Stanley Omnilock 45HOM Mortise Locks
Stanley Omnilock
a Product Group of Stanley Security Solutions, Inc.
11
Installation Instructions for Stanley Omnilock 45HOM Mortise Locks
Finishing the installation
18 Check operation
Check the operation of the lock. For example, check
that:
❐ door latches and opens properly
❐ deadbolt operates properly
❐ key access works
❐ door gap is 1/8” (3 mm)
❐ auxiliary bolt is held inside the case when the door
is closed.
For assistance, contact your local Stanley Omnilock
dealer.
19 Test lock
To test the lock for proper operation before the lock
is programmed, follow these instructions:
For keypad locks
1 Press 1234 for the 2000 series, or 5011234
for the 500 series.
The green light flashes and the latch unlock.
2 Turn the lever and open the door.
During the unlock time, the green light flashes. Then
the red light flashes and the latch relocks.
For magnetic stripe or proximity card locks only
Note: If the lock has a proximity card reader, it may
have already been activated by the presence of an
object near the card reader.
1 Align the magnetic stripe card with the V mark by
the card slot.
2 Insert and then remove the card.
The green light flashes and the latch unlocks.
3 Turn the lever and open the door.
During the unlock time, if using the Programming
Default ID Card, the green light flashes. Then the red
light flashes and the latch relocks.

Stanley Omnilock 45HOM Specifications

General

Brand	Stanley
Model	Omnilock 45HOM
Category	Locks
Language	English