Stanley PB2500 - Page 40

40
ENGLISH
Stem retention/removal feature
worn out on Nose Piece
Inspect Nose Piece and replace O-
ring and ball/pin as required
Cannot insert rivet
Incorrect Nose Piece for rivet.
Refer to Accessories Manual. Select
and install correct nose piece
Broken rivet stems jammed in Nose
Equipment.
Service and clean Nose Assembly.
Refer to Accessories Manual.
Check Nose Equipment is correct for
rivet
Broken rivet stems jammed in Pulling
Head Assembly.
Empty Stem Collector and clear
Pulling Head Assembly.
Debris in Nose Piece.
Service and clean Nose Assembly.
Rivet stem does not break
Battery is low voltage.
Charge battery
Setting load of rivet is beyond tool
capacity.
Reset tool to home, remove rivet &
use appropriate tool to set rivet.
Incorrect Nose Equipment for rivet.
Refer to Accessories Manual. Select
and install correct nose equipment
Nose Equipment and Stem Collector
full of stems.
Empty Stem Collector and check
Nose Equipment for damage before
re-use