• Keep dirt and foreign matter out of the hydraulic system of the tool as this will cause the tool to
malfunction.
• Care should be taken to ensure that spent mandrels do not create a hazard.
• The mandrel collector must be emptied when approximately half full.
• DO NOT use the tool without mandrel collector installed.
• DO NOT let air exhaust opening on the mandrel collector face in the direction of the operator or other
persons.
• Contact with hydraulic uid should be avoided. To minimise the possibility of rashes, care should be taken
to wash thoroughly if contact occurs.
• Material Safety Data Sheets for all hydraulic oils and lubricants is available on request from your tool
supplier.
STANLEY Engineered Fastening policy is one of continuous product development and improvement
and we reserve the right to change the specication of any product without prior notice.
2. SAFETY RULES
This technical datasheet must be read with particular attention to the safety warnings and operating instructi-
ons listed in the ProSet XT3 and ProSet XT4 Instruction Manual, by any person tting or operating the nose
assemblies and hand tools.
3. INTENT OF USE
The accessories in combination with the ProSet XT3 and ProSet XT4 tools are designed for placing Stanley
Engineered Fastening blind rivets only.
To Next Page
Loading...
Need help?
General
