• Fit the Fixed Bottle Assembly (1) over the locating pins in Fixed Bottle Adaptor Assembly (2).
• Rotate the Fixed Bottle Assembly (1) outer so that the aperture in the Fixed Bottle Assembly (1) inner is
fully exposed.
• Screw on the Retaining Nut (4) and tighten using atommy bar.
8. MCS5000 ADAPTER KITS
The MCS5000 Adapter Kits enable the tool to be connected the MCS5000 remote vacuum rivet stem collector.
To replace the stem collector with the MCS5000 Adapter Kit proceed as follows:
PREPARING THE BASE TOOL TO ACCEPT THE MCS5000 ADAPTER KITS
IMPORTANT - READ THE SAFETY WARNINGS LISTED IN THE PROSET XT3 AND PROSET XT4 INSTRUCTION
MANUAL CAREFULLY BEFORE PUTTING INTO SERVICE.
IMPORTANT - THE AIR SUPPLY MUST BE TURNED OFF OR DISCONNECTED BEFORE FITTING OR
REMOVING THE MCS5000 ADAPTER KITS.
Refer to g.18 below. Refer also to the Proset XT3 and Proset XT4 Service Manuals 07900-09410 and 07900-
09411.
• Operate the tool so that the Piston (76003-02120 or 76004-02120) moves to the fully rear position.
• Continue to depress the trigger, then turn o the air supply to the tool using the On/O Valve (76003-
03700). The Piston Assembly will then stop in the fully rear position.
• The air supply must be disconnected.
• Rotate Stem Collector (76003-05200) anti-clockwise and remove from the Collector Adapter (76003-
05104).
• Unscrew and remove the Deector Retaining Nut (76003-05102) and the Stem Deector (76003-05101).
• Remove the Collector Adapter (76003-05104), including ORing (07003-00530).
• Unscrew and remove the End Cap Assembly (76003-05110), including ORing (07003-00508). Observe
caution when removing the End Cap Assembly (76003-05110) as it will be subjected to acompressive
force from Spring (76003-02030).
• Remove Spring (76003-02030).
• If vacuum extraction is not required when using the Pin Tail Deector, unscrew and remove the Ejector
Nozzle (76003-05105 / 76004-05105) from the Piston (76003-02120 or 76003-02120).
To Next Page
Loading...
Need help?
General
