ENGLISH
•
Remove Gasket
(34)
from the Handle Assembly
(33).
•
Remove 0 Ring
(42)
from the Hydraulic tube of the Head Assembly
(12).
•
Separate the Handle Assembly
(33)
from the Head Assembly
(12).
•
Remove Gasket
(32)
from the Head Assembly
(12).
Assemble in reverse order noting the following points:
•
Seals and gaskets should be checked for damage and replaced as necessary. Lubricated seals and gaskets
with Molykote 55M grease (07992-00075).
•
Apply Loctite 243 to Clamp Nut
(50)
and tighten to torque 14.91 Nm (11ftlb).
•
Ensure that the Air Chamber
(56)
is screwed fully into the Handle Base
(46)
so that there are no visible
gaps between the parts.
6.1.5 Trigger
•
Using the 2mm Pin Punch (07900-00158) drive the Trigger Pin
(36)
out of the Handle Assembly
(33)
and
remove the Trigger Button
(6.)
•
Unscrew the Trigger Valve
(35)
using the trigger valve extractor (07900-00692).
POP a
Avdel°
20
• Remove Gasket (34) from the Handle Assembly (33).
• Remove O Ring (42) from the Hydraulic tube of the Head Assembly (12).
• Separate the Handle Assembly (33) from the Head Assembly (12).
• Remove Gasket (32) from the Head Assembly (12).
Assemble in reverse order noting the following points:
• Seals and gaskets should be checked for damage and replaced as necessary. Lubricated seals and gaskets
with Molykote 55M grease (07992-00075).
• Apply Loctite 243 to Clamp Nut (50) and tighten to torque 14.91 Nm (11ftlb).
• Ensure that the Air Chamber (56) is screwed fully into the Handle Base (46) so that there are no visible
gaps between the parts.
6.1.5 Trigger
• Using the 2mm Pin Punch (07900-00158) drive the Trigger Pin (36) out of the Handle Assembly (33) and
remove the Trigger Button (6.)
• Unscrew the Trigger Valve (35) using the trigger valve extractor (07900-00692).
ENGLISH
20
To Next Page
Loading...
Need help?
General
