6. Clean the cutting means regularly. Stop the engine,
switch the machine off and unplug the spark plug
connector before checking.
7. Trim in steps when the grass is very high. Do not cut
the total height at once.
8. Wait until the machine has come to a standstill before
placing it down.
9. The trimmer head is equipped with a bumper helping
to cut the trimmer line while operating. Tap the bumper
on a stable surface and the spool will release a fresh
trimmer line.
10. A knife which is integrated in the guard will cut the
line to the required length. Always remove the knife
protection before operation and refit afterwards.
TIPS
1. For best results, do not cut wet grass because it tends
to stick to the cutting means and guard, prevents proper
discharge of grass clippings, and could cause you to slip
and fall.
2. Pay special attention when performing the work close
to trees and bushes. The cutting means can damage
sensitive bark, and damage fence posts.
3. Regularly remove clippings and dirt around the
trimmer head with a switched off product.
4. After use, switch the machine off, unplug the spark
plug connector and let it cool down.
8. Maintenance and repairs
STORAGE
1. Store the machine and its accessories in a dark, dry,
frost-free, wellventilated place.
2. Always store the machine in a place that is
inaccessible to children. The ideal storage temperature
is between 10 and 30 degree. For best results,
cover the machine with a proper cloth or foil to protect it
against dust.
3. If you are not going to use the machine for an
extended period of time (more than 1 month), empty the
fuel tank before storing it.
GENERAL CLEANING
1. Regular and proper cleaning will not only ensure safe
use but also prolongs the life time of this machine.
2. Switch the machine off, let it cool down and unplug
the spark plug connector.
3. Clean the machine with a damp cloth and neutral
soap. Use a brush for areas that are hard to reach.
4. In particular clean ventilation openings and the cutting
means after every use with a cloth and brush.
5. Remove stubborn dust with high pressure air (max. 3
bar).
6. Check for any damage and worn. Repair damages
according to this instruction manual or bring it to an
authorised service centre before using this machine
again.
CUTTING MEANS AND GUARDS
WARNING! Wear safety gloves when
working on the cutting means and around it!
Use proper tools to remove debris, e. g. a
wooden stick! Never use your bare hands!
1. Keep the cutting means and guards clean and free of
debris. Remove grass clippings.
2. Replace a worn or damaged cutting means with new
ones of the same type.
G
B
To Next Page
Loading...
