6
2. Intended use
The intended purpose of the device is the trimming of
lawns or grass for private use.
If the device is not used for its intended purpose, or in
case of any modification to the device, the manufacturer
does not accept any liability.
Please also observe the safety notes, the assembly and
operating instructions, as well as the general applicable
accident prevention regulations.
3. Safety instructions
Warnings! Read this instruction carefully before
operating this machine. Make sure that you are familiar
with the controls and properly operate the machine.
Following this instructions, you can reduce the risk of
fire, electric shock and personal injury.
Save all warnings and instructions for future reference.
TRAINING
1. Read the instructions carefully. Become familiar with
the owner's manual before attempting to operate the
machine.
2. Never allow children or people unfamiliar with these
instructions to use the machine. Local regulations can
restrict the age of the operator.
3. Never operate while people, especially children, or
pets are nearby.
4. Keep in mind that the operator or user is responsible
for accidents or hazards occurring to other people or
their property.
5. Do not operate the machine when you are tired, ill or
under the influence of alcohol, drugs or medication.
PREPARATION
1. This machine can cause serious injuries. Read
the instructions carefully for the correct handling,
preparation, maintenance, starting and stopping
of the machine. Become familiar with all controls and
the proper use of the machine.
2. Beware of overhead power lines.
3. Avoid operating while people, especially children, are
nearby.
4. Dress properly! Do not wear loose clothing or
jewellery, which can be caught in moving parts. Use of
sturdy gloves, non-skid footwear and safety glasses is
recommended.
5. Use extra care when handling fuels. They are
flammable and the vapours are explosive. The following
points should be observed.
- Use only an approved container.
- Never remove the fuel cap or add fuel with the power
source running.
Allow engine and exhaust components to cool down
before refuelling.
- Do not smoke. Never refuel indoors.
- Never store the machine or fuel container inside where
there is an open flame, such as near a water heater
- If fuel is spilled, do not attempt to start the power
source, but move the machine away from the spillage
before starting.
- Always replace and securely tighten the fuel cap after
refuelling.
- If the fuel tank is drained, this should be done outdoors.
6. If the cutting mechanism strikes any foreign object
or the machine starts making any unusual noise or
vibration, shut off the power source and allow the
machine to stop. Disconnect the spark plug wire from
the spark plug and take the following steps:
- Inspect for damage;
- Check for, and tighten, any loose parts;
- Have any damaged parts replaced or repaired with
parts having equivalent specifications.
OPERATION
1. This machine should not be used for any other
purpose than described.
2. While operating, always wear substantial footwear
and long trousers. Do not operate the machine when
barefoot or wearing open sandals. Wearprotective
glasses or goggles.
3. Thoroughly inspect the area where the machine is to
be used and remove all objects which can be thrown by
the machine.
4. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
5. Never operate the machine with damaged guards or
without the guards in place.
6. Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.(
G
B
To Next Page
Loading...
