I
Select Simplex/duplex mode (DX type only)
Youcan changebetweensimplexandduplexmodeusingsoftwarecom-
mandsin anyemulationmode.The commandtodo thisis:
<ESC>[ D n
wheren is an ASCIIvalueof either“1”or “2”. If n is set to”1”, thenthe
printerwillentersimplexmode,andif nis“2”,theprinterwillenterduplex
mode.
Iftheprinterisinsimplexmode,the”1”optionwillhavenoeffect.Ifthe“2”
optionischosenwhiletheprinteris in duplexmode,itis onlyvalidifthen
face-downoutputstackhas been selected.The pagecontainingthis com-
mandwillbecomethe faceof thedouble-sidedpage.
If the printer is in duplexmode, the “l” option will force single-sided
printing,commencingwiththepagecontainingthiscommand.Iftheprinter
isalreadyinduplexmode,thepagecontainingthiscommandwillbcforced
to bethe faceof thenextdouble-sidedpage.
The DUPLEXlight on the frontpanel will indicatethe currentsimplex/
duplexstatusof theprinterfollowingreceiptof thiscommand.
34
To Next Page
Loading...
