VERTICAL POSITION COMMANDS
Set line spacing to II8 inch
Mode ASCII Decimal
Hexadecimal
Both <ESC> “0” 21 48
1B 30
Sets the distance the paper advances or reverses in subsequent line feeds
to l/8 inch.
Set line spacing to 7172 inch
Mode ASCII Decimal
Hexadecimal
Both
<ESC> “1”
27 49
IB 31
Sets the distance the paper advances or reverses in subsequent line feeds
to T/i’2 inch.
Set line spacing to 716 inch
Mode ASCII Decimal
Hexadecimal
Std. <ESC> “2” 27 50 IB 32
Sets the distance the paper advances or reverses in subsequent line feeds
to l/6 inch.
Set line spacing to n/216 inch
Mode ASCII
Decimal
Hexadecimal
Both
<ESC> “ ” n
3 21 51 n 1B 33 n
Sets the distance the paper advances or reverses in subsequent line feeds
to 4216 inch, where n is between 0 and 255. If n = 0, in Standard mode
the line-feed distance is set to 0, but in IBM mode this command is ignored.
Set line spacing to n/72 inch
Mode ASCII
Decimal
Hexadecimal
Both <ESC> “A” n
27 65 n IB 41 n
In Standard mode, sets the distance the paper advances or reverses in
subsequent line feeds to n/72 inch, where n is between 0 and 85. If n
=O, the line spacing is set to 0.
In IBM mode this command does the same except that (1) the new line
spacing does not take effect until the next < ESC > “2” command, and
(2) if n = 0, the < ESC > “A” command is ignored.
To Next Page
Loading...
