COMMAND SUMMARY
MODE CODE
FUNCTION
<BEL>
Bell
CBS>
Backspace
<HT>
Horizontal tab
<LF>
Line feed
<VT>
Vertical tab
<FF>
Form feed
<CR>
Carriage return
<so>
Expanded printing for one line
<SI>
Condensed printing
<DC]>
Set printer on-line
<DC2>
Cancel condensed printing
k.? -=DC2’
Pica pitch
<DC3>
Set printer off-line
<DC4>
Cancel one-line expanded printing
<CAN>
Cancel last line
<ESC> <LF>
Reverse line feed
<ESC> <FF>
Return to top of current page
<ESC> <SO>
Expanded print for one line
<ESC> <SI>
Condensed printing
<ESC> <EM> <O>
Manual feed
<ESC> <EM> <4> Auto feed
<ESC> <EM> “R”
Eject paper from ASF
<ESC> <EM> “T”n
Set print start position on ASF
Std.
<ESC> ““PI
Increase character spacing
< ESC > “!” n
Select master print mode
<ESC> “#”
Accept MSB as is
< ESC > “$” nl n2
Absolute horizontal tab in inches
<ESC> “%” <O>
Select ROM character set
<ESC> “%” <I>
Select download character set
< ESC > “‘?di” “0”
Select ROM character set
< ESC > “%” “1”
Select download character set
IBM <ESC> “=” <O> nln2mOmZm2dId2....
Define download characters
Std.
<ESC> “8~” CO> nln2mOmlm2dId2....
Define download characters
-z ESC > “*” n0 nl n2 ml m2 ____ Select graphics mode
<ESC> “-” <O>
Stop underlining
<ESC> “-” <I >
Start underlining
< ,22C > ‘6 - )) “0”
Stop underlining
< ESC > ‘I - >’ ‘r ]”
Start underlining
< ESC > “1” n0
Select vertical tab channel
< ESC > “0”
Set line spacing to l/8 inch
< ESC > “1”
Set line spacing to 7/60 or 7/72 inch
;ydy <ESC> “2”
Execute < ESC > “A”
< ESC > “2”
Set line spacing to l/6 inch
< ESC > “3” n
Set line spacing to n/180 or n/216 inch
IBM <ESC> “4”
Set top of page at current position
Std.
<ESC> “4”
Select italic characters
Std.
< ESC > “5”
Select upright characters
IBM < ESC > “5” < 0 >
Cancel automatic line feed
IBM < ESC > “5” < I >
Set automatic line feed
< ESC > “6”
Select character set #2
108
To Next Page
Loading...
