Define line spacing to n/72 inch
Mode ASCII
Decimal Hexadecimal
IBM I <ESC> “A” n
I 27 65 n IIB 41 n
I
Defines the distance the paper advances or reverses in subsequent lines
feeds to n/72 inch, where n is between 1 and 85. If n = 0, this command
is ignored. The new line spacing does not take effect until the next < ESC >
“2” command.
Execute < ESC > “A”
Mode
ASCII
Decimal Hexadecimal
IBM
<ESC> “2” 27 50 IB 32
Sets the line spacing to the value defined by the last preceding < ESC > -
“A” command. Sets the line spacing to l/6 inch if there is no preceding
< ESC > “A” command.
Line feed
Mode ASCII
Decimal Hexadecimal
Both <LF>
10 OA
Prints the current line and feeds the paper to the next line. If DIP switch
1-2 is ON, also moves the next print position to the left margin. See the
preceding commands for the line spacing.
Reverse line feed
Mode
ASCII Decimal Hexadecimal
Both 1
cESC> <LF>
127 10
1B OA
Prints the current line and feeds the paper in the reverse direction to the
preceding line. If DIP switch l-2 is ON, also moves the next print position
to the left margin. See the preceding commands for the line spacing.
Ignored when friction feed is used.
Select forward feed mode
1 ASCII Mode
Decimal
-
I
--
Hexadecimal
Std.
<FS> “F” 28 70 IC 46
Cancels the reverse feed mode and selects forward feed mode. This is the
default setting at power-up.
Select reverse feed mode
-
Mode I ASCII
Decimal Hexadecimal
I
Std.
<FS> “R” 28 82
1c 52
Selects reverse feed mode. Reverses the direction of all vertical move-
ments. Ignored when friction feed is used.
70
To Next Page
Loading...
