35
Print Position Control
<LF>
0A
Line feed
Prints the current line and feeds the paper to the next line.
<CR>
0D
Carriage return
The <CR> code is valid only if memory switch 3-1 is set to 1. (The
factory setting is 0.)
If the <CR> code is valid:
The function of the <CR> code changes according to the setting of
memory switch 5-8.
When memory switch 5-8 is set to 0 (factory setting): Functions in
the same way as an <LF> code (CRLF).
When memory switch 5-8 is set to 1: Executed only when printing.
The paper is not fed (CR).
<ESC> “a” n
1B 61 n
Feed paper n lines
Prints the current line and feeds the paper n lines (where n is between
1 and 127).
<HT>
09
Horizontal tab
Moves the print position to the next horizontal tab stop. Ignored if
there is no next horizontal tab stop on the current line.
<ESC> “A” n
1B 41 n
Defines n/72-inch line spacing
Defines the distance that the paper advances in subsequent line feed.
The line spacing defined here is set by <ESC> “2”.
0 n 85
The default value of n is 12 (1/6-inch feed)
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION
≤ ≤
To Next Page
Loading...
