Star Micronics SLIP SP298 SERIES - Page 42

39
<ESC> <GS> “a” n
1B 1D 61 n
This function specifies a position alignment.
This function aligns the specified position of all print data of 1 line.
The position is aligned as shown below.
n = (00)H, “0”: Left align (default)
= (01)H, “1”: Center
= (02)H, “2”: Right align
ABC
ABCD <ESC><GS> “a”0
ABCDE
ABC
<ESC><GS> “a”1 ABCD
ABCDE
ABC
<ESC><GS> “a”2 ABCD
ABCDE
Note:
• This is only valid when it is input at the start of the line.
• The position alignment is executed on the width of the specified
print area.
• The parts that are skipped because of horizontal tabs are also
included in the data for position alignment.
CODE
HEX
FUNCTION