Star Micronics TUP900 Series - Control Board Module (TBD900 Series)

Rev 0.01
TUP900 Series Specifications Manual
10—1
10. Control board module (TBD900 Series)
Refer to the separate TBD900-24-A / PBD-9 Secification Manual for details.
However, the Paper End Near Sensor Unit (NEU-T900), Control Panel Unit (OPA-T900), and the Power Connector
Cable (PBD-9), which are optional parts for the TBD900-24-A, are standard equipment on the TUP900.
The table below shows the factory settings for the DIP Switches and Memory Switches.
1) the DIP Switches (DIPSW)
a) Main Board
DIPSW Factory settings
DIPSW1-1 ON
DIPSW1-2 ON
DIPSW1-3 ON
DIPSW1-4 ON
DIPSW1-5 ON
DIPSW1-6 ON
DIPSW1-7 ON
DIPSW1-8
OFF
DIPSW2-1 ON
DIPSW2-2 ON
DIPSW2-3 ON
DIPSW2-4 ON
b) RS-232 I/F Board
DIPSW Factory settings
DIPSW1-1 ON
DIPSW1-2 ON
DIPSW1-3 ON
DIPSW1-4 ON
DIPSW1-5 ON
DIPSW1-6 ON
DIPSW1-7
OFF
DIPSW1-8
OFF
2) Memory Switches
MSW Factory settings
MSW 0 0000
MSW 1 0000
MSW 2 0000
MSW 3 0000
MSW 4 0000
MSW 5 0000
MSW 6 0000
MSW 7 0000
MSW 8 0000
MSW 9 0000
MSW A 0000
MSW B 0000
MSW C 0000
MSW D 0000
MSW E 0000
MSW F 0000