Settings
STAR TRAC FITNESS 1 of 4 637-1371 Rev: A
Settings Definitions
E-TR and E-TRx (LED Display)
The display assembly contains two modes for settings.
• “Manager Mode”
• “Maintenance Mode”
In these modes, there are settings that can be changed for the club/facility or country for which the treadmill has been
installed. There are also technical settings which determine how the unit will perform.
Engaging Manager Mode
• From the idle screen (unit is powered on but not in a program), press and hold
, then , then
.
The word “MANAGER” will temporarily show in the marquee window and then go to the first setting.
Engaging Maintenance Mode
1. From the idle screen (unit is powered on but not in a program), press and hold
, then , then
.
The word “MAINTENANCE” will temporarily show in the marquee window, then go to the first setting.
Once in the Engineering Mode:
•
will be used to move between the different settings.
•
will be used to change the values for the settings.
• The
saves any changes made or enters into the sub-menus (if applicable).
•
is used to exit a sub-menus or exit the maintenance mode.
To Next Page
Need help?
General
