19
Re-installing the automatic sheet
feeder
❏ Open the front cover of the printer.
❏ Carefully lower the automatic sheet feeder into
the printer, making sure that the two round tabs
on either end of it enter into the corresponding
slots inside the printer. You should have the
automatic sheet feeder angled towards the front
of the printer (at about the same angle that it was
when you pulled the feeder forward while
detaching it).
❏ Lower the automatic feeder all the way down.
When you do, it should naturally slip into place,
with the part that holds the paper angled slightly
towards the back of the printer.
❏ Close the front cover of the printer.
To Next Page
Loading...
