Star SP700 Series - Adjusting the Print Head and Platen

1-2. Adjusting the Print Head and Platen
To adjust the le side gap, remove the adjustment
bushing [4] screw in the le side frame and move the
adjustment bushing [4] up and down.
1.
To adjust the right side gap, remove the adjustment
bushing [5] screw in the right side frame and move the
adjustment bushing [5] up and down.
Measure the gap as described in 1-1 above.
If the measurement value is not with 0.4 to 0.45, repeat
steps 1 and 2.
If the adjustment is within that range, tighten the screws
you loosened or removed.
2.
3.
4.
5.
- 3 -
Gap
-
+
[5]
[4]
Gap
-
+
Fig. 1-2 Adjusting the Gap (Left)
Fig. 1-3 Adjusting the Gap (Right)